Ender pearl blaster design

Options

Download Add to favorites Report

Description

This is my 360° ender pearl cannon with a min range of 400m and max of 3300m.

To use it, align yourself in the middle with the lantern texture, then pick a direction (f3 facing degree helps) and then place the pearl near the edge for maximum distance, and near the barrel for minimum distance, though you should not place within 4-5 water pixels of the barrel cuz the pearl might get pulled by the falling tnt. There are 3 power modes, 25%, 50%, 100%, as well as dry and wet mode (wet mode douses the pearl so it doesnt bounce but takes 20% of the range) and with all 6 possibilities, it covers all the possible ranges.

Wet mode is toggled with the bell.

Wet mode: 25% = 400-700m | 50% = 900m-1500m | 100% = 1500-2800m
Dry mode: 25% = 400-800m | 50% = 1200m-1700m | 100% = 1800m-3300m

Example: you wanna go 2.2km? Place the pearl in the middle, not the edge, not near the barrel, and it should give around that if you use the 100% power option (wet mode is preferrable because its within the range of both wet and dry modes) and activating it is just opening and closing the barrel in the water

Lets say 400m? Then place the pearl near to the barrel but not too near (as i said 4-5 pixels away minimum) and use 25% (again wet mode is preferred.)

3.3km? Dry mode, 100% power, pearl near the edge of the obsidian.

This applies to any direction btw but you have to eyeball it.

Other Creations From Gibbicikli

Add a Comment