3D Tnt Quarry 1.21.3 (1.13.1 and above)
| Category | Flying Machines |
| Theme | Other |
| Size | Small |
| File Format | .litematic |
| Submitted by | Jisotron |
| Posted on | November 16th, 2024 10:29 AM EST |
| Download(s) | Has been downloaded 96 times |
This is a generic TNT duper 3D quarry by Comet's slimetone machines, built in Minecraft 1.21.3 (works for 1.13.1 and above):
Front Part (TNT Quarry): Contains the TNT duper mechanism, which duplicates and drops TNT to explode and hollow out the area below.
Back Part (Movement Mechanism): A flying machine that pushes the TNT duper horizontally, allowing it to move left to cover new sections of terrain.
Extendable Design: The back part setup is modular, so you can extend it as far as needed to clear massive areas efficiently.
Important: This has to be done after placing the tnt block. While building you will notice that there is a detector rail and a minecart on top of a slime block. This rail and minecart have to be move on the slimeblock via a Piston. So place a temporary block next to the slimeblock where the minecart is located on the schematic. then place a detector rail and a minecart on it and a piston next to it facing the slimeblock. Then activate the Piston by a lever or a redstone block... afterwards destroy the temporary block and the redstone source.
To start the machine you have to break the redstone block that is closest to you on the picture (on the crosshair) . If you want to stop the machine you have to place the redstone block on the same position again.
If you want to automatically stop it, just can just place the redstone block in same position, but extend it in the X or Z coordinate.
Example on my schematic: You have your redstone block on (0/0/0) and you want to stop it 64 blocks later, you have to place the next redstone block on (0/0/64)
