smurfmaster2000
| Member since | May 1st, 2016 |
| Last visit | February 14th, 2018 |
| Creation(s) | 1 |
| Comment(s) | 1 |
I just hate all the effort involved in downloading a world save file. So if you want to spend an hour:
Downloading it from an ad-supported site, un-RAR-ing the files via command line (I'm on a Mac) so extra pain...no buit-in rar support, loading up the world file (fortunately I have my test-spigot-server-with-world edit, all ready) and THEN spending 30 minutes searching for where in the @#$# the build is (no it wasn't at 0, 0, ugh)... and then end up using NBT editor to pull the coordinates from the Player Data file (?!) of the author (whoch was fortunately, though sloppily, left in the world save folder uploaded), then FINALLY FINDING the actual build. UGH!
Then...half the build was stained clay, half in wool. So made the whole thing one material (stained clay). Removed all the extraneous glowstone from the build, then made sure the area of the schematic was covering the exact area of the statue only, and THEN finally... most importantly... actually making the center point of the schematic at a PROPER spot, not up and off to the side randomly, but at the base-very-center of the build, turning it to face a known/stated direction (north) so that people can rotate it properly once they load it, to suit there needs.
So to save everyone else the effort, I uploaded my schematic instead that I already had to make for my own purposes.
Downloading it from an ad-supported site, un-RAR-ing the files via command line (I'm on a Mac) so extra pain...no buit-in rar support, loading up the world file (fortunately I have my test-spigot-server-with-world edit, all ready) and THEN spending 30 minutes searching for where in the @#$# the build is (no it wasn't at 0, 0, ugh)... and then end up using NBT editor to pull the coordinates from the Player Data file (?!) of the author (whoch was fortunately, though sloppily, left in the world save folder uploaded), then FINALLY FINDING the actual build. UGH!
Then...half the build was stained clay, half in wool. So made the whole thing one material (stained clay). Removed all the extraneous glowstone from the build, then made sure the area of the schematic was covering the exact area of the statue only, and THEN finally... most importantly... actually making the center point of the schematic at a PROPER spot, not up and off to the side randomly, but at the base-very-center of the build, turning it to face a known/stated direction (north) so that people can rotate it properly once they load it, to suit there needs.
So to save everyone else the effort, I uploaded my schematic instead that I already had to make for my own purposes.
Super Mario 3D Statue on May 26th, 2016 07:59 AM EST
